The best way to remove these bushings is to use a torch and set the rubber on fire. Let it burn one to two minutes then hit the eye so the rubber and the inner sleeve falls out. Then use a punch and a hammer and catch the end of the outer sleeve and curl it shrubnotch.buzzted Reading Time: 1 min.
Front Leaf Spring Bushings for Chevy 1/2 and 3/4 ton - Superlift Springs Only. This bushing kit contains enough bushings and sleeves to complete a pair of front springs. SHOW MOREPrice:Oct 15, Keep the jack under the rear end. Do one end of a single spring at a time, removing the bolt securing the spring into the front pocket and/or the leaf spring and frame bolts on the rear shackle as required.
This keeps the rear end properly located. 3. Remove the bolt and lower the jack completely to perform the repair described below. Feb 27, 1. Cut through the metal bushing with a hacksaw cutting it into halves.
2. Soak it in PB blaster or dishwashing soap (i like the soap) 3. Place a large socket on the backside that the bushing will slide into and use a deepwell socket slightly smaller than the outer lip of the bushing.
4. Place it in your vice or press and push them out. Add to Compare. Front Spring Bushings for ' GM Trucks. As low asAdd to Wish List. Add to Cart. Add to Compare. Main Eye Bushings for ' GM Trucks. As low asAdd to Wish List.